34
3
1, 2
OPEN
1
Using a Memory Card
ª
Inserting a Memory Card
Before inserting a Memory Card, be sure to turn the Camera/Recorder off.
1
Slide the [OPEN] Lever to the right and open the Card Slot
Cover.
2
While holding the Memory Card with its cut corner facing
right, insert it into the Card Slot.
3
Close the Card Slot Cover.
ª
[ACCESS] Lamp
While the Camera/Recorder is accessing the Card (reading, recording,
playback, erasing, moving of images), the [ACCESS] Lamp
1
lights up.
≥
While the [ACCESS] Lamp is on, never attempt to open the Card
Compartment, to pull out the Card, to turn off the Camera/Recorder power,
or to switch the [TAPE/CARD] Selector. Such actions will damage the Card
and cause the Camera/Recorder to malfunction.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Recording on the Memory Card
Still pictures can be recorded on a Card from the Camera/Recorder lens as
well as from scenes that have already been recorded on a cassette.
The size of images that are recorded using this Camera/Recorder is
approximately 1,680,000 pixels, and recording of images with a size that is
larger than a million pixels is called mega-pixel still-picture recording.
Compared to images of normal recording, images that are created by
mega-pixel still-picture recording can be printed out clearer.
ª
Card Photoshot
Recording a picture through the Camera/Recorder lens
(CAMERA Mode)
1
Slide the [TAPE/CARD] Selector to [CARD].
2
Set [PICTURE SIZE] on the [CARD SETUP] Sub-Menu to
[1488
t
1128] or [640
t
480].
≥
If you select [1488
t
1128], you can take pictures with higher resolution.
(Mega-Pixel Recording)
3
Press the [PHOTO SHOT] Button.
≥
The [
ø
] Indication will light in red.
1
During Card Photoshot recording, the following functions are
disabled.
≥
Digital Zooming
(
l
≥
Digital Effect Functions
(
l
≥
Title In/Creation
≥
Frame Mode
(
l
≥
The Camera/Recorder is automatically turned off when you leave it for
about 5 minutes without performing any photoshot recording.
≥
When recording dark scenes, set [LOW LIGHT SHOT] on the [CARD
SETUP] to [AUTO] and then record.
(
l
Recording from a cassette (VCR Mode)
1
Slide the [TAPE/CARD] Selector to [CARD].
2
Start playback and press the [PHOTO SHOT] Button at the
scene you want to record.
≥
The size of the images input externally or recorded from a tape to the
card becomes [640
t
480].
≥
While the image is being recorded, it stays still for a few seconds.
≥
Please refer to “Recording to a Card from other equipment”
(
l
,
regarding the recording to a card from other equipment.
Selecting the quality of Card Photoshot images
1
Set [CAMERA FUNCTIONS] or [VCR FUNCTIONS] >> [CARD
SETUP] >> [REC MODE] >> a desired image quality (FINE,
NORMAL, ECONOMY).
¿
F 7 1488
1
3
TAPE
CARD
PHOTO
SHOT
1
2
TAPE
CARD
2
PHOTO
SHOT
2
1
MENU
VOL/JOG
PUSH
MENU
VOL/JOG
PUSH
1
BACK
LIGHT