16
Chapter
1 Applying Eff
ects to
Video and Sound
[DECAY]
The afterimage effect can be added to video.
The following diagram shows an example of the decay
effect.
Decay effect
Rotary 1
Rotary 2
Rotary 3
Rotary 4
Rotary 5
OFF
ON
0-32
DECAY
OFF
TIME
16
Select [ON] or [OFF] to specify whether or not to apply the
effect using the rotary 2 control.
The factory default setting is [OFF].
Set [TIME] in the range of [0] to [32] using the rotary 3
control.
The factory default setting is [16].
This time setting is applied to No. 1066 (219) pattern.
NOTE
The decay effect cannot be applied to both input source video
A and B at the same time. When the decay effect is enabled for
one video, it is automatically disabled for the other video.
[PAINT]
The image tone can be decreased to generate painting-like
video.
The following diagram shows an example of the paint
effect.
Paint effect
Rotary 1
Rotary 2
Rotary 3
Rotary 4
Rotary 5
OFF
ON
0-7
PAINT
OFF
LEVEL
4
Select [ON] or [OFF] to specify whether or not to apply the
effect using the rotary 2 control.
The factory default setting is [OFF].
Set [LEVEL] in the range of 0 to 7 using the rotary 3 control.
The factory default setting is 4.
This level setting is applied to No. 1034 (211) transition
pattern.
[NEGA]
The brightness of video can be inverted.
The following diagram shows an example of the negative
effect.
Negative effect
Rotary 1
Rotary 2
Rotary 3
Rotary 4
Rotary 5
OFF
ON
OFF
ON
NEGA
OFF
C
Y
OFF
Select [ON] or [OFF] to specify whether or not to apply the
Y signal negative setting [Y] using the rotary 2 control and
the chroma signal negative setting [C] using the rotary 3
control, respectively.
The factory default setting is [OFF] for both items.
[MIRROR]
The mirror effect can be produced in the horizontal or
vertical directions.
The following diagram shows an example of the mirror
effect.
Horizontal direction
Horizontal and
vertical directions
Vertical direction
Mirror effect
Rotary 1
Rotary 2
Rotary 3
Rotary 4
Rotary 5
OFF
ON
OFF
ON
MIRROR
OFF
V
H
OFF
Select [ON] or [OFF] to specify whether or not to apply the
mirror setting in the horizontal direction [H] using the rotary
2 control and in the vertical direction [V] using the rotary 3
control, respectively.
The factory default setting is [OFF] for both items.