35
Basic Oper
ation
To select a pattern
The currently selected pattern number is shown in the
event number, transition, pattern number, and internal video
display area of the setting screen (
PAGE
PATTERN
0001
1
Press the PATTERN button to turn on.
2
Set the pattern number by entering a numeric
value with the numeric keys or using the + and
−
keys.
3
Press the key.
NOTE
If the number with no corresponding pattern (invalid
number) is specified, the nearest valid pattern number
appears.
To set the transition time
4HECURRENTLYSETTRANSITIONTIME-%4)-% ISSHOWNIN
the area where the event number, transition time, pattern
number, and internal video are displayed on the setting
screen (
PAGE
The factory default setting is [02:00
F
] [2 seconds].
ME TIME
02:00
F
The maximum value that can be set is [33:09
F
=I
PI OR;
F
=IPI
FORTHETIMEDISPLAYFORMhSECONDSFRAMESvAND;
F
]
FORTHETIMEDISPLAYFORMhFRAMESv
NOTE
Even if a value exceeding the maximum value is selected, the
maximum value is automatically set.
1
Press the ME setting button to turn on.
2
Set the transition time by entering a numeric
value with the numeric keys or using the TIME
rotary control.
Example: To set “2:05” (2 seconds 5 frames),
enter “2.5.”
4HE;3934%-=SUBMENUOFTHE;3%450=MENUCAN
be used to select the transition time display form
hSECONDSFRAMESvORhFRAMESv
PAGE6OL
3
Press the key.
Program Preset Transition
Program preset transition is an effect of switching from
PROGRAMVIDEOBASEVIDEO TOPRESETVIDEOVIDEOUSEDAS
ANEFFECT ANDVICEVERSA
)TISEXECUTEDINTHESAMEMETHODASDESCRIBEDINh!"
4RANSITIONvEXCEPTFORSETTING;490%=TO;02'02%=IN3TEP
4HE/.%7!9BUTTONISDISABLEDBECAUSEITLIMITSTHE
switching direction only from preset video to program video
THEBUTTONmASHESWHENPRESSED
NOTE
During program preset transition, the buses are switched to
each other every time transition is carried out.
This state of bus switching can be checked with lighting and
flashing of the ME PVW button.
When the buses are in the same state as the initialization,
the ME PVW button is lighted. When transition is carried out
once and the bus source is switched to the other, the ME PVW
button flashes.
Keying
+EYINGISACOMBININGEFFECTOFADDINGSOURCEVIDEO"ASA
hKEYvTOSOURCEVIDEO!ANDVICEVERSA
4HEKEYINGMETHODSINCLUDEDTHEBASICPATTERNKEY
(
PAGE6OL CHROMAKEY
PAGE6OL LUMINANCE
KEY
PAGE6OL ANDTITLEKEY
PAGE6OL
The following diagram shows an example of the basic
PATTERNKEY
+EYINGISEXECUTEDWITHTHETRANSITIONLEVEROR!54/4!+%
button.
1
Select source video A and source video B
(
page 33).
2
Slide the transition lever to the A side (or B side).
3
Select the key pattern to use (
“To select a
pattern” on this page).
Patterns registered as direct patterns (
PAGE
can be used.
4
Process the selected pattern by applying
effects including border, shadow, and trail
(
page Vol.2-3).
Summary of Contents for AG-HMX100P
Page 47: ...MEMO 47 ...
