– 143 –
Chapter 8 Using SmartUI — Menu list
[SETUP] screen
Screen
Corresponding button
Setting details and setting value
SET01:TC/UB
Sets the time code or user bits.
When an item other than [UB] is selected for the counter display on the [HOME] screen, the time code setting screen appears, and when
[UB] is selected on the [HOME] screen, the user bits setting screen appears.
r
Time code settings screen:
f
To set the time code, press the <
%
/REW> button to change to the time code setting mode.
f
The setting values of each digit of the time code are from
[0] to [9]
(decimal).
<
%
/REW> button
[TCG]
Starts and exits the time code setting mode.
f
The time code setting is applied when the setting
mode exits.
When the <
%
/REW> button is pressed, [SET] is
displayed in black and white inversion, and the time
code setting mode is set.
When the <
%
/REW> button is pressed again,
[SET] returns to the normal display, and the time
code setting mode exits.
<STOP> button
[TC_MD]
Selects the advance setting mode for the built-in
time code generator.
[F-RUN]
Use this function to advance the time code
continuously, regardless of the P2 card recording
operation. Set to this position to, for example, set
the time code to the current time or externally lock
the time code.
[R-RUN]
Use this function to advance the time code only
during recording. A time code recorded normally will
be continuously recorded.
f
If a clip is deleted, or if the frame rate is set to
[24P]/[24PA] and the recording continues to
a frame other than [24P]/[24PA], continuous
recording may fail.
<FF/
)
> button
[
−
]
Decreases the setting value of the selected digit in the time code.
<PLAY/PAUSE> button
[
+
]
Increases the setting value of the selected digit in the time code.
<COUNTER> button
[TC/UB]
Switches to the user bits setting screen.
<RESET> button
[RST]
Resets all time code setting values to 0.
<MONITOR SEL> button
[
→
]
Moves the selected digit in the time code to the right. When the selected digit moves to the right edge, it
moves back to the left edge.
r
User bits settings screen:
f
To set the user bits, press the <
%
/REW> button to change to the user bits setting mode.
f
The setting values of each digit of the user bits are from
[0] to [F]
(hexadecimal).
<
%
/REW> button
[UBG]
Starts and exists the user bits setting mode.
f
The user bits setting is applied when the setting
mode exits.
When the <
%
/REW> button is pressed, [SET] is
displayed in black and white inversion, and the user
bits setting mode is set.
When the <
%
/REW> button is pressed again,
[SET] returns to the normal display, and the user
bits setting mode exits.
<STOP> button
[TC_MD]
Switches to the advance setting mode for the built-in time code generator. The setting contents are the
same as when [TCG] is selected.
<FF/
)
> button
[
−
]
Decreases the setting value of the selected digit in the user bits.
<PLAY/PAUSE> button
[
+
]
Increases the setting value of the selected digit in the user bits.
<COUNTER>
[TC/UB]
Switches to the user bits setting screen.
<RESET> button
[RST]
Resets all user bits setting values to 0.
<MONITOR SEL> button
[
→
]
Moves to the right of the selected digit in the user bits. When the selected digit moves to the right edge, it
moves back to the left edge.
indicates factory setting values.
