– 45 –
Chapter 3 Recording and Playback — Special recording functions
t
During playback, setting or canceling the shot mark is not
available, but while pausing the playback, setting or canceling the
shot mark is available.
t
When video data obtained by a single shooting session by hot
swap recording comprises multiple clips, the shot mark can be
set or deleted only if all P2 cards containing that video data are
inserted in the card slots. Also, with video data comprising multiple
clips like this, the shot mark can be added to the top clip only.
Text memo recording function
Text memos can be added to any video point while a clip is being recorded or played back.
Only clips with a text memo added can be selected and displayed as thumbnails, thumbnails and time codes at text memo positions can be displayed
and played back from text memo points, and only required positions can be selected and copied. (page 107)
Adding text memos
1
Assign text memos to the desired <USER> buttons (<USER
MAIN>/<USER1>/<USER2>) or the <RET> button on the lens
on the setting menu [SW MODE] screen.
For details, refer to “Setting menu basic operations” (page 118).
2
During recording or a pause after recording, press the
button to which the text memo is assigned (the <USER>
buttons (<USER MAIN>/<USER1>/<USER2>) or the <RET>
button on the lens).
[TEXT MEMO] is displayed, and the text memo is added to the video
clip that was displayed when the button was pressed.
@
@
NOTE
t
Up to 100 text memos can be recorded to a single clip.
t
Text memos cannot be added in loop recording, interval recording
and one-shot recording. If an operation is invalid, [TEXT MEMO
INVALID] is displayed when the button is pressed.
