- 174 -
This sets the blur amplitude of the Image Stabilizer during recording. (
)
This sets the blur frequency of the Image Stabilizer. (
When you press the WHITE BAL button, you can assign ATW.
This fine-adjusts the intensity of red. (
≥
This function’s default setting is “0”.
This fine-adjusts the intensity of blue. (
)
≥
This function’s default setting is “0”.
Sets which White Balance mode to use when the WHITE BAL button is pressed to switch to the
PRST position.
[BLUR AMPLITUDE]
[1]/[2]/[3]/[4]/[5]
[BLUR FREQUENCY]
[1]/[2]/[3]
[ATW SET]
[OFF]:
Does not assign ATW when the WHITE BAL button is pressed.
[Ach]:
Sets the White Balance mode to ATW when the WHITE BAL button is pressed to
switch to [Ach].
[Bch]:
Sets the White Balance mode to ATW when the WHITE BAL button is pressed to
switch to [Bch].
[PRST]:
Sets the White Balance mode to ATW when the WHITE BAL button is pressed to
switch to [PRST].
[ATW TARGET R]
[ATW TARGET B]
[WB PRESET]
[3200K]/[5600K]/[VAR]
AG-UX180ED(DVQP1171ZA)_E.book 174 ページ ２０１６年１１月２８日 月曜日 午前１１時３２分
