6 (E)
1
2
3
Installing the unit on the camera recorder
4
Follow the steps below to install the unit on the camera recorder.
<Note>
With some camera recorder models, the software version may have to be updated. Consult your dealer.
1
Check that the unit’s coin screw is up all the way.
If you attempt to attach the unit while the coin
screw is screwed down, you may damage the
connectors.
2
Remove the two screws at the rear of the camera
recorder to remove the connector cover.
<Note>
Keep the connector cover and the screws in a safe
place.
3
Align the unit’s guides with the battery holders of
the camera recorder, and push it in the direction of
the arrows until it clicks into place.
4
Push the coin screw down and tighten it securely.
Coin screw
Screws
Connector cover
Summary of Contents for AJ-CA905G
