17
1
Set the unit to the local mode (by setting the LOCAL/MENU/REMOTE switch to the
LOCAL position).
2
When the BEGIN or END button on the front panel is pressed, the current position
is set as the BEGIN or END point.
Setting the BEGIN and END points
[Front panel]
1
Set the unit to the remote mode (by setting the LOCAL/MENU/REMOTE switch to
the REMOTE position).
2
When the BEGIN or END button on the front panel is pressed, the BEGIN or END
point is displayed while the button is held down.
The settings are not changed.
Displaying the BEGIN and END points
1
Set the unit to the menu mode (by setting the LOCAL/MENU/REMOTE switch to the
MENU position).
2
Select the “MEMORY MODE” setup menu item, and select the repeat playback
mode. (See page 29)
Setting the repeat playback mode
Setting
Operation
OFF
M-STOP
REPT1
CONT
Normal operation
The tape stops near the BEGIN point when it is fast-forwarded
or rewound.
When the tape playback reaches the END point, the tape is
rewound to the BEGIN point, where it stops.
When the tape playback reaches the END point, the tape is
rewound to the BEGIN point and playback is repeated.
<Notes>
O
The picture quality will deteriorate when the same tape is repeatedly played back over and
over again. As a general guideline, replace the tape with a new one after about 100 repeat
playback operations.
O
When repeat playback is to be initiated using a consumer-use tape, the unit will not operate
even if CONT has been selected as the setup menu item No.111 “MEMORY MODE” setting.
(See page 29)
Operation
3
Set the LOCAL/MENU/REMOTE switch to the LOCAL or REMOTE position.
Summary of Contents for AJ-D250P
Page 79: ......
