52
Setup menus
(continued)
AUDIO (continued)
*1 Displayed menus may vary depending on the settings in
menu No. 25 SYSTEM FREQ. For details, refer to
“Menus which are displayed” (page 32).
“_____” indicates the factory setting.
No./Item
Description of setting
750
ANA CH1/2
SEL
For selecting the channel for the signal output to the
analog audio output terminal CH1/CH2.
0000
CH1/2
0001
CH3/4
0002
CH5/6
0003
CH7/8
759*
1
DV PB ATT
For selecting the audio output level during DV format
playback.
0000
OFF :
The audio output level is not attenuated.
0001
ON :
The audio output level is attenuated.
760*
1
REC PT
MUTE
For selecting whether to mute the sound at the joins
in the recording during DV or DVCAM format
playback.
0000
OFF :
The sound is not muted.
0001
ON :
The sound is muted.
762
AUD RATE
CON
For setting whether the tape is to be played back
without passing the signals through the rate converter
(without activating the digital filter) in the digital audio
output unit.
0000
OFF :
The tape is played back without passing the signals
through the rate converter.
0001
ON :
The signals are passed through the rate converter,
and the tape is played back.
<Note>
ON/OFF control is exercised for channels 1 through 8
at the same time. Separate settings cannot be
performed on a channel by channel basis.
765
CUE OUT
SEL
For setting whether to output the analog CUE signal
to CH1/2 for the analog audio output.
0000
OFF :
The analog CUE signal is not output.
The PCM audio signal is output when the speed
range is less than
j
1.0
k
to +1.0
k
; while the no
audio signal is output at any other speed.
0001
ON :
The analog CUE signal is output.
The PCM audio signal is output when the speed
range is less than
j
1.0
k
to +1.0
k
; while the
analog CUE signal is output at any other speed.
781*
1
IN IMP SEL
For setting the analog audio input impedance.
0000
600 :
600
h
0001
HIGH :
High impedance
<Note>
Regardless of this setting, the impedance is set to
3k
h
.
when “–60 dB” is selected as the menu item
No.701 to 702 settings.
No./Item
Description of setting
782
EMBD CH
SEL
Set the channels to multiplex SD-SDI output.
0000
CH1-4 :
0001
CH5-8 :
<Note>
When tape other than DVCPRO HD (LP) is played,
CH1 to CH4 is always multiplexed.
783
AUDIO CH
SEL
For selecting channels that are adjusted with the
audio volume control on the front panel and displayed
on the audio level meter.
0000
CH1-4 :
Select CH1–CH4.
0001
CH5-8 :
Select CH5–CH8.
784
MONI SEL
INH
Select enabled/disabled for MONITOR SELECT
button operation on the front panel.
0000
OFF :
Operation is enabled.
0001
ON :
Operation is disabled.
0002
ON1 :
Operation is disabled in the FULL display mode
while the operation is enabled only in the FINE
display mode.
