146
Maintenance and Inspections: Inspections Before Shooting
Make sure you check that the system is operating normally before embarking on a shoot. We recommend using a color video
monitor to check the image.
1
Mount a charged battery pack.
2
Turn the power switch ON and check that 5 or
more BATT indication marks appear.
z
If fewer than 5 BATT indication marks appear,
replace the battery with a fully-charged battery.
3
Insert a P2 card into the slot cover and close
the slide cover.
Confirm that the P2 card access LED for the inserted
card slot lights up in orange. If P2 cards are inserted
into multiple card slots, only the P2 card access LED for
the first-inserted P2 card lights up in orange. Then, the
other P2 card access LEDs light up in green when P2
cards are inserted.
If the access LED for the P2 card slot in which a P2
card is inserted keeps blinking in green, or if there is no
display, recording is not possible on that particular P2
card.
1
Set the zoom to electric zoom mode and
check the zoom operation.
Check that the image changes to telephoto and wide
angle.
2
Set the zoom to manual zoom mode and
check the zoom operation.
Turn the manual zoom lever to check that the image
changes to telephoto and wide angle.
3
Set the iris to automatic adjustment mode and
aim the lens at objects with different degrees
of brightness, to check that the automatic iris
adjustment operates normally.
4
Set the iris to manual adjustment mode and
turn the iris ring, to check the manual iris
adjustment.
5
While holding down the instant iris automatic
adjustment button, aim the lens at objects
with different degrees of brightness, to check
that the instant iris automatic adjustment
operates properly.
Note
Some lenses do not have an instant iris automatic
adjustment function.
6
Return the iris to automatic adjustment mode
and change the GAIN switch setting to L, M,
and H, to check the following items:
z
The iris is adjusted for objects with the same bright-
ness according to the switch setting.
z
The gain value displayed on the viewfinder screen
changes according to the switch setting.
7
When a lens with an extender is mounted, set
the extender to the operating position to
check that the extender operates properly.
Preparing for Inspections
1
2
3
Inspecting the Camera Unit
Maintenance and Inspections
Inspections Before Shooting
AJ-HPX3100G(VQT3A79)_E.book 146 ページ ２０１０年９月１７日 金曜日 午後９時２１分
