16
P2 Driver
Installing a Windows P2 driver
Install the P2 driver on the supplied CD-ROM on
your PC.
The dedicated software is installed at the same
time.
For the installation procedure, see the P2 driver
installation manual.
<Note>
When installing two or more devices, be sure to
install the drivers for each device separately.
Installing a Macintosh P2 driver
This driver software enables a Macintosh to
access content on a P2 card inserted in the
device.
Perform the following steps to install the driver.
1
Insert the supplied CD-ROM.
2
Double-click the “
Macintosh
” folder on the
CD-ROM.
3
For Mac OS X 10.5
Double-click the
Leopard
folder.
For Mac OS X 10.6
Double-click the
SnowLeopard
folder.
For Mac OS X 10.7
Double-click the
Lion
folder.
4
Double-click the
P2Drive
folder.
5
Double-click “
P2DriveFamilyDriver
Install.dmg
” in the
P2Drive
folder.
6
The driver software installation process will
now start. Follow the instructions given in the
installation screen.
<Notes>
z
Without installing the P2 driver, a sufficiently
high transfer speed cannot be obtained.
z
The latest driver information can be viewed at
the following website.
http://pro-av.panasonic.net/
Uninstallation
For Windows:
For the uninstallation procedure, see the
installation manual.
<Notes>
z
At installation, be sure to check that the device
is switched on before connecting.
z
The P2 driver can be used with either USB 2.0
or USB 3.0.
AJ-PCD30P_E-VQT3R23.book 16 ページ ２０１１年９月２８日 水曜日 午前１１時６分
