6
Before Use
z
While AJ-PCD30 (referred to below as “the
device”) is connected to the personal
computer, install the required drivers from the
CD-ROM.
For details, refer to the installation manual and
“P2 Driver” (page 16) in this manual.
z
The device may become warm during use, but
this is not a malfunction.
z
When the device is used internally, it may be
necessary to connect the device with part of
the USB cable passing outside your PC. In this
case, be sure sufficient space behind the PC
that is to contain the device.
Overview
The device is a P2 card-dedicated data transfer device with a USB 3.0 interface and a 3 slot drive for
writing and reading P2 content to and from P2 cards using the USB 3.0/2.0 connection in a Windows
PC or Macintosh.
The device is capable of making high-speed transfers of clip data shot with a memory card camera
recorder for P2 cards to a personal computer (Windows/Macintosh).
This device supports not only the transferring and copying of clips recorded on P2 cards, but also direct
editing.
Features
z
It is capable of high speed data transfer of
over 1.5 Gbps
*1
.
z
It can be used as either an external or an
internal drive. (only Windows)
z
Supports both Windows and Macintosh
operating systems.
z
The device can also be connected to a
USB 2.0 Windows PC/Macintosh.
z
Up to 2 devices may be connected to a single
PC.
*2 *3
*1 This is the transfer speed using the multiple P2 card E series over the USB 3.0 connection.This will vary according
to conditions such as the type of file being transferred, the system, the application software, and the version and
the number of the P2 card.
*2 Connect the USB terminal of the device to your computer using the PC USB port. If the USB terminal of the device
is connected to a USB terminal hub then errors may occur, such as the computer not recognizing the device, or not
applying the necessary drivers. (We cannot guarantee proper operation of the device when connected to a USB
hub.)
*3 When using a Macintosh with 2 of the devices connected, or with the device and at least two other P2 drive
connected, avoid duplication among the volume labels of the P2 cards.
Correct operation cannot be guaranteed if the volume labels are duplicated or left without being set (
“
NO NAME
”
is
displayed).
AJ-PCD30P_E-VQT3R23.book 6 ページ ２０１１年９月２８日 水曜日 午前１１時６分
