– 63 –
Chapter 4 Shooting — Setting the electronic shutter
Setting the electronic shutter
Shutter mode
The shutter modes available on the electronic shutter of the camera and selectable shutter speeds are as follows.
Using a fixed shutter speed
f
To remove flicker caused by lighting
f
To shoot fast-moving subjects clearly
Using the synchro scan mode
f
To shoot so that stripe patterns in the horizontal direction are reduced when shooting on the monitor screen
f
To shoot moving subjects with special effects
Adjusting with the <SEL/PUSH SET> dial button and <MODE/MENU CANCEL> button
The shutter mode can be switched and adjusted using the <SEL/PUSH SET> dial button and <MODE/MENU CANCEL> button.
Enabling shutter mode
1
Press the <SEL/PUSH SET> dial button.
[SHUTTER ON] indication appears in the center of the screen. The shutter speed value is indicated and the shutter is enabled.
If you press the dial button again, [SHUTTER OFF] indication appears in the center of the screen and the shutter mode is disabled.
Every press of the dial button switches [SHUTTER ON]/[SHUTTER OFF].
Changing the shutter mode setting
1
Press the <SEL/PUSH SET> dial button and enable the shutter mode.
[SHUTTER ON] indication appears in the center of the screen.
2
Press the <MODE/MENU CANCEL> button and select a shutter mode.
Every press of the button switches the modes as follows, and the selected mode is highlighted in orange.
Shutter mode
→
variable frame rate mode
→
white balance variable mode
f
Variable frame rate mode can be selected only when [ON] is set in the main menu
→
[SCENE FILE]
→
[VFR].
f
White balance variable mode can be selected only when [VAR] is set in the main menu
→
[SW MODE]
→
[W.BAL PRESET], and the <WHITE
BAL> switch is set to the <PRST> position.
3
Press the <SEL/PUSH SET> dial button and select shutter mode or synchro shutter mode.
Each time the button is pressed, the normal shutter mode and synchro shutter mode will be toggled.
4
Turn the <SEL/PUSH SET> dial button upward/downward and change the settings.
In synchro shutter mode, you can change the mode quickly by turning the button while it is pressed.
5
Press the <MODE/MENU CANCEL> button several times until the highlight of the mode disappears.
@
@
NOTE
t
The synchro scan display can be switched to [sec] (second) or [deg] (degree) in the main menu
→
[SCENE FILE]
→
[SYNC SCAN TYPE].
t
Also, synchro scan setting can be made in the main menu
→
[SCENE FILE]
→
[SYNCHRO SCAN].
t
Once selected, the shutter speed value and synchro scan speed value are saved even after the camera is turned off.
t
Whichever mode the electronic shutter is used in, the higher the shutter speed, the lower the sensitivity of the camera becomes.
t
When the aperture is in the automatic mode, it will increasingly open and the depth of focus will become shallower as the shutter speed is increased.
t
Under lighting conditions using fluorescent lighting or other discharge tube, horizontal stripes might appear on screen. If this happens, this can be
improved by adjusting the shutter speed.
t
A subject that quickly crosses the camera may appear distorted when shot. This is due to the method applied for reading the signals from the pickup
device (MOS sensor), and is not a malfunction.
Viewfinder screen display for shutter
Summary of Contents for AJ-PX230 Series
Page 12: ...Before using the camera read this chapter Chapter 1 Overview ...
Page 153: ...Maintenance of the camera or frequently asked questions are described Chapter 9 Maintenance ...
Page 161: ...This chapter describes the specifications of this product Chapter 10 Specification ...
Page 169: ...Web Site http www panasonic com Panasonic Corporation 2016 ...