– 156 –
Chapter 8 Connecting to External Devices — Connection function via <USB2.0 DEVICE> or <USB3.0 HOST> terminal
[SELECTED PART.]
Number of partitions selected
For [FAT] and [OTHER] (other storage devices)
[PARTITION]
[FAT]/[OTHER]
[VENDOR]
Vendor name
[MODEL]
Model name
[SIZE]
Total capacity (unit: GB)
[FREE CAP.]
Remaining capacity (unit: GB)
[SELECTED PART.]
Number of folders selected
4 Partition or folder information
For [TYPE S] and [P2STORE] (partition information)
Displays a checkmark when a target partition is selected
[NO.]
Partition number
[MODEL]
P2 card model name
[PARTITION NAME]
Name assigned to the partition
[DATE]
Partition record date
[TIME]
Partition record time
[SERIAL]
P2 card serial number
For [FAT] and [OTHER] (folder information)
Displays a checkmark when a target partition is selected
[NO.]
Folder number
[FOLDER NAME]
Folder name (excluding the CONTENTS folder)
[DATE]
Folder creation date
[TIME]
Folder creation time
@
@
NOTE
t
For [TYPE S] storage devices, you can switch the display between the partition name and serial name using the control stick.
t
If there is an invalid partition in [P2STORE], the partition information is displayed in gray.
t
The remaining free space of the corresponding partition can be checked in the main menu
→
[CLIP]
→
[PROPERTY]
→
[FREE CAP. OF
PARTITION].
Selecting the target folder/partition in the explorer screen
You can display all clips included in the selected partition/folder as thumbnails by selecting partitions/folders as targets. You can display up to six
partitions/folders. When the seventh partition/folder is specified, setting is disabled and a warning is displayed.
Fig. 1
1
In the explorer screen, place the cursor on the partition/folder.
2
Press and hold the control stick (for one second or more).
The partition/folder is selected and a checkmark is displayed. (Fig. 1)
The selected target partition/folder is valid until the storage device is disconnected or the power is turned off. To release the selected partition/folder,
hold down the control stick (for one second or more) again on the selected partition.
Press the <CANCEL> button to deselect all partitions/folders.
@
@
NOTE
t
In [TYPE S] storage devices, [MODEL] is [UNKNOWN] and clips recorded across other partitions will not be one normal clip. Copying clips to a [TYPE
S] storage device changes the partition of the copy destination [MODEL] to [UNKNOWN].
t
The partition name can be set when a [TYPE S] storage device is used. The partition name that has been set is displayed in [PARTITION NAME] on
the explorer screen.
