– 96 –
Chapter 4 Shooting — Setting the time data
Genlock input and camera
output phase
SDI output (HD)
None
Video output and SDI output
(SD)
l
Time code output
l
Setting and displaying the counter
If you display the counter using the <COUNTER> button, the counter value is displayed on the time code display of the viewfinder/LCD monitor. Counter
value is displayed as hour, minute, second. This is not displayed during playback.
You can set either of two types in the main menu
→
[DISPLAY SETUP]
→
[REC COUNTER].
[TOTAL]:
The camera will continuously count until reset using the <RESET> button. Even if you replace the P2 card or turn off the power, the value will
be maintained.
[CLIP]:
Each time you start recording the counter value will clear and the count will start from 0. You can shoot always while checking the recording time
of the clip you are currently shooting.
@
@
NOTE
t
If the <RESET> button is pressed while the counter value is displayed, the counter value is reset. It will start again from 0.
t
The counter value is one second of [0:00.00] to [9:59.59].
