55
4
4-7-5 Setting the Marker Displays
The center, safety zone, safety zone area and frame markers
may be set to ON or OFF, along with specifications of the marker
types. To set and select markers, go to the <VF MARKER>
screen from the VF page and select the appropriate options.
For directions on navigating the menu, see [4-6-2 Setting Menu
Options].
<Note>
The indication MKR:A at the upper right of the screen shows the
current indication status. To view TABLE B, press the MARKER
SELECT button. This changes the indication to MKR:B, allowing
you to view the settings.
4-7-6 Marker Check Screen Displays
(MARKER SELECT button function)
The viewfinder can display a screen that allows you to view the
marker settings of the AJ-SPX900E.
Pressing the MARKER SELECT button on the camera-recorder
switches the marker indication as follows.
Marker A
Marker B
No marker
If the menu option FRAME SIG is set to 16:9 as the information
of Marker A and 4:3 as the information of Marker B, then the
16:9 and 4:3 view angles can easily be checked with the button,
as required.
4-7-7 Checking Return Video Signal in the
Viewfinder
The viewfinder displays the return video signal input to the
GENLOCK IN connector while the RET button at the lens is held
down.
To enable this capability, select CAM RET for the menu option
RET SW. This option can be found in the <SW MODE> screen,
which is accessible from the CAM OPERATION page.
9)0$5.(5!
ޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓޓ
0.5$
7$%/($
&(17(50$5.
6$)(7<=21(
6$)(7<$5($
)5$0(6,*
)5$0(0$5.2))
)/$0(/9/
MARKER SELECT button
center marker
Markers
Safety zone
The view angle specified through the menu
option FRAME SIG is displayed.
6:02'(!
5(76:5(&&+(&.
6%/./9/
$872.1((6:21
6+'$%%6:&7/21
&2/25%$566037(
6*$,12))/0+
'6*$,12))'6*$,1
'=2206(/=220
(&8'$7$6$9(2))
(&85(&&+.6:55(9,(:
#,52:''PINKUJDQQMࡍࠫ㧞㧜㧜㧡ᐕ㧟㧞ᣣޓ᳓ᦐᣣޓඦᓟ㧡ᤨ㧞㧜ಽ
