E-4
EN
GL
IS
H
6
Place the AJ-YBX200G into the terminal of
the board in Step
5
and fix it by using the
four 2.6 mm screws.
7
Reconnect the cable removed in Step
5
as
it was originally.
8
Reinsert the No.5 board into its original
position. In this operation, allow the cable
connected in Step
7
to run along the slot of
the No.5 board. (See Figure
5
) Insert the
flexible cables removed in Step
4
into the
original positions.
9
Return the side panel to the original
position and secure it with the screws. In
this operation, ensure that the cable
disconnected in Step
5
is not caught in the
slot.
If the flexible cables are not locked or the
board is inserted at a slant, the camera
recorder may have trouble recording.
2.6 mm
screws
00.AJ-YBX200G(VQT1K80).book 4 ページ ２００７年７月６日 金曜日 午後７時４０分
