– 89 –
Audio insert editing function with 23.98 Hz VTR system and 30 Hz
external operating environments
O
Points to note
N
The function will not work unless the following conditions are met.
(a) The system frequency of the VTR must be set to 23.98 Hz.
(b) The black burst reference signal must be connected.
(c) The settings below must be selected for the following items on the TC/CHR CONVERT menu:
RC_30SYS (F6)
ON
RC_TC (F10)
30TC
(d) Use the AES input or analog input as the audio input signals, and make sure that embedded audio signals
are not selected.
(Otherwise, the signals may be edited with the audio and video phases misaligned.)
(e) The settings below must be selected for the following item on the INTERFACE SETUP menu:
VAR LIMT (F10)
OFF
This function can be executed for audio insert editing only. Bear in mind that, in the status where the settings
above have been completed, the following editing modes are prohibited and cannot be set.
—Assemble editing mode
—Insert (video) editing mode
—Insert (CUE selection) editing mode
—Insert (TC selection) editing mode
Bear in mind that if, after the edit channel selection has been entered, one of the applicable prohibition condi-
tions has been established from an external source (9-pin or 232C connector) or by loading a user file or by
other means, the EDIT preset command or insert operation (video, CUE or TC) will be masked and executed.
Summary of Contents for AJHD3700B-PE
Page 193: ... 193 ...
