106
Adjustments and Settings for Recording: Chromatic Aberration Compensation (CAC)
If the following messages are displayed when the jog dial
button is pressed, the data cannot be deleted.
7
Move the arrow (cursor) to YES by turning the jog dial
button and then press the jog dial button. When the
write operation is completed, the following message is
displayed.
The following error messages are displayed in the viewfinder
when CAC does not operate properly or CAC files cannot be
read properly.
Notes
When lens optical accessories (converter lens,
attachment) are installed, the CAC may not operate
properly due to changes in the optical characteristics of
the lens. In this case, turn off the CAC function.
When focus servo is used with Canon lenses, data must
be recorded after initialization in the automatic initialization
mode. The state where the focus ring is moving may be
recorded.
When the CAC does not operate and no error message is
displayed, the version of the software for the lens may be
out of date and invalid. Please contact the lens
manufacturer.
Error message
Measures
DELETE NG
NO CARD
(No SD memory card is
inserted)
Insert an SD memory card.
DELETE NG
ERROR
(Data cannot be deleted)
It is assumed that the SD
memory card is defective.
Replace the card.
DELETE NG
WRITE PROTECT
(The SD card is write protected)
Eject the SD memory card and
release write protection.
DELETE NG
CANNOT ACCESS
(It is impossible to access the
data)
It is impossible to access the SD
memory card while the card is in
use. After completion of the
respective operations, perform
the delete operation again.
DELETE NG
NO FILE
(No file is available)
Select the file No. containing
astigmatism files and perform
the delete operation.
When CAC file does not operate properly
Error message
Meanings
Measures
FILE MEMORY
FULL
When the CAC file is
read from the SD
memory card to
memory in the unit in
EMPTY mode, the
built-in memory is full.
Read the CAC file in a
mode other than
EMPTY mode.
CAC FILE DATA
NOT FOUND
When the CAC
function is set to ON
and no CAC file
applicable to the
connected lens is
available. This is
displayed when the
power of the unit is
turned on.
Read the CAC file that
is applicable for the
lens to be used.
CAC LENS DATA
INVALID
When the unit cannot
respond to the return
data from the lens, or
when any responses
other than ones as
defined in the CAC file
are returned.
This lens does not
support CAC
correction. Although it
cannot execute CAC
correction, using this
lens presents no
problems.
LENS
INITIALIZE NOT
COMPLETED
Initialization of the
lens position detection
(focus/zoom) in the
encoder type is not
completed yet.
Turn the focus/zoom
ring to through the
intermediate point of
the operation range.
AJ-HPX2700G-VQT1V27_eng.book 106 ページ ２００８年９月２日 火曜日 午後５時４３分
