Control reference guide (continued)
– 16 –
Fan
Cool the memory card recorder.
If the fan stops, “E-10” appears on the counter display.
SIGNAL GND terminal
Connect to the signal ground terminal on the component
connected to the memory card recorder to minimize
noise. It is not a safety ground.
ANALOG COMPONENT VIDEO OUT connectors
Output analog component video signals.
ANALOG COMPOSITE VIDEO OUT connectors
Output analog composite video signals.
Video signals containing superimposed information can
be output through the VIDEO OUT 3 connector.
Switch ON or OFF with the SUPER switch
on the
front panel.
RS-232C connector
Connect a personal computer or other component to
control the memory card recorder.
ANALOG AUDIO OUT connectors
Output analog audio signals.
MONITOR OUT connectors
During playback, a mixed signal is output from the
CH1/CH2/CH3/CH4 audio signals. This signal is
switched by the MONITOR MIX button
on the front
panel.
LAN connectors
Connect to a network with a 100BASE-TX/10BASE-T.
Note:
Do not remove the P2 cards while the LAN is
connected for use.
Optional connectors
Installing the optional board (AJ-YAD850G) provides an
IEEE1394 interface.
DVCPRO/
DV
(OPTION)
100BASE-TX
AC IN
SIGNAL
GND
AES/EBU
CH1•2
IN
CH3•4
IN
CH1•2
OUT
CH3•4
OUT
SDI
IN
OUT
1
2
3
(SUPER)
ACTIVE
THROUGH
ANALOG
ANALOG
REMOTO
Y
VIDEO
IN
PB
PR
Y
PB
PR
ON
OFF
75
Ω
REF VIDEO
IN
ON
OFF
75
Ω
1
2
3
(SUPER)
REMOTO IN
ENCODER REMOTE
RS-232C
CH1
CH3
CH1
CH3
CH2
AUDIO
IN
CH4
CH2
CH4
AUDIO
OUT
TC
IN
TC
OUT
MON
L
MON
R
SERVICE ONLY
Rear Panel (2/2)
