– 33 –
Play List (continued)
Importing and storing play lists
Importing play lists from an external source
(1) Press the PLAYLIST button to switch to the play
list screen.
(2) Open the OPERATION sub menu and select
IMPORT.
(3) Select the import destination.
[SLOT1-SLOT5]: The play list data stored on any of
the P2 cards in slots 1 to 5 is
selected.
[SD CARD]:
The play list data stored on the SD
memory card is selected.
[SELECTED CLIPS]: The clips selected on the thumbnail
screen are turned into play list
data.
(4) Press the SET button.
The importing of the play list data starts.
Play list importing is now completed.
Exporting play lists [EXPORT]
• Exporting the data to P2 cards [SLOT1-SLOT5]
The play list data is stored in the designated area on the
P2 card in the selected slot.
Select [OPERATION]
→
[EXPORT]
→
[MEMORY], and
select the slot with the card on which the data is to be
stored.
• Storing on SD memory card [SD CARD]
The play list data is stored using the designated format
in the designated folder on the SD memory card. The
designated filename is allocated to the data.
• Use an SD memory card which has been formatted
using this unit. (See page 26)
Note:
If play list data has already been saved, it will be
overwritten.
Notes:
• Play lists set prior to importing will be deleted.
• Bear in mind that if the number of events exceeds
100, the play list data for the events exceeding
100 will not be imported.
Playing the play lists
You can start playing a play list from the event where the
pointer is positioned by pressing the PLAY button while
the play list screen is displayed. If the pointer is moved to
event 1 and the PLAY button is pressed, play list play
starts from the head of the list. To stop the play list play,
press the STOP button.
During play, it is also possible to set the play TC which
will output a continuous value from the prescribed value.
In this case, however, the original value will be used as
the VITC, SDI or other TC.
The initial value is set and the output TC selected using
[SETTING] on the menu bar.
To play the TC from the prescribed value during play:
• Set the TC replacement mode.
Select [SETTING]
→
[REPLACE TC]
→
[REPLACE],
and set [ON].
• Set the initial TC value.
Input the initial TC value by selecting [SETTING]
→
[REPLACE TC]
→
[START TC]
→
[TC]
→
[START
TC: ].
For AJ-SPD850P:
• Set [DF] or [NDF] for TC.
Select [START TC]
→
[DF], and then set [DF] or
[NDF].
• Bear in mind that if the event where the pointer is
positioned has not been registered, it cannot be played
on the play list.
• To play the play list, insert all the P2 cards whose
events have been registered on the play list. Otherwise,
the play list will not be played properly.
Resetting play lists
All the play list events can be reset.
Select [OPERATION]
→
[DELETE ALL], and then select
[YES]. To cancel the resetting, select [NO] instead.