– 88 –
Chapter 5 Web Screen — [Setup] screen
[IPv4 network]
Item
Description of settings
[IP address(IPv4)]
Enter the IP address of the camera. Enter an IP address that does not conflict with the ones set for
computers or other network cameras.
f
Factory setting: [192.168.0.30]
[Subnet mask]
Enter the subnet mask of the camera.
f
Factory setting: [255.255.255.0]
[Default gateway]
Enter the default gateway of the camera.
Multiple IP addresses cannot be used for the default gateway.
f
Factory setting: [192.168.0.1]
[Common]
Item
Description of settings
[HTTP port]
Assigns the port number of HTTP individually (port number when accessing with a browser).
[1]…[65535]
f
Factory setting: [80]
The following port numbers are used by the camera. Do not use them.
[20]/[21]/[23]/[25]/[42]/[53]/[67]/[68]/[69]/[110]/[123]/[161]/[162]/[443]/[554]/[995]/[10669]/[10670]/[49152]/
[49200]…[49299]/[59000]…[61000]
[ROP port]
Assigns the port number individually when connecting to ROP.
[49152], [49200]…[49299]
f
Factory setting: [49152]
[Line speed]
Sets data transmission speed.
[Auto]:
Sets the transmission speed automatically.
[100M-Full]:
100 Mbps full-duplex
[100M-Half]:
100 Mbps half-duplex
[10M-Full]:
10 Mbps full-duplex
[10M-Half]:
10 Mbps half-duplex
It is recommended to use the initial setting [Auto] for normal use.
f
Factory setting: [Auto]
[Max RTP packet size]
Sets whether to limit the RTP packet size transmitted from the camera while viewing camera images using
RTP.
[Unlimited (1500byte)]:
Unlimited (1500 bytes)
[Limited (1280byte)]:
Limited (1280 bytes)
It is recommended to set [Unlimited (1500byte)] for normal use.
Select [Limited (1280byte)] when the packet size of the communication line to be used is limited.
For the maximum packet size of your communication line, consult your network administrator.
f
Factory setting: [Unlimited (1500byte)]
