– 87 –
Chapter 5 Web Screen — [Setup] screen
Item
Description of settings
[User name]
Enter a user name.
Number of characters that can be entered: 1 to 32
Characters that cannot be entered: Double-byte and single-byte symbols " & : ; \
Entering a user name that has been already registered and clicking the [Set] button overwrites the user
information.
[Password]
[Retype password]
Enter a password.
Number of characters that can be entered: 4 to 32
Characters that cannot be entered: Double-byte and single-byte symbols " &
[Access level]
Sets the access level for users.
[1. Administrator]:
Allows full operation of the camera.
[2. Live only]:
Allows only to display the [Live] screen. No operation and setting of the camera is available.
f
Factory setting: [2. Live only]
[User check]
Click in [User check] to check the registered users.
A registered user is indicated as “registered user name[Access level]”. (Example: admin[1])
Clicking the [Delete] button on the right deletes the selected user.
[Host auth.] tab
Register host authentication information to restrict computers (IP addresses) that can access the camera.
Item
Description of settings
[Host auth.]
Sets whether to authenticate hosts.
[On]:
Authenticates the hosts.
[Off]:
Does not authenticate the hosts.
f
Factory setting: [Off]
[IP address]
Enter the IP address of the computer to permit its access to the camera.
A host name cannot be entered as an IP address.
If the IP address/mask length of subnet is entered, computers that can access the camera can be
restricted per subnet. When 192.168.0.1/24 is entered and [1. Administrator] is selected for [Access level],
computers with 192.168.0.1 to 192.168.0.254 can access the camera in the access level [1. Administrator].
Entering an IP address that has been already registered and clicking the [Set] button overwrites the host
information.
[Access level]
Sets the access level for hosts.
[1. Administrator]:
Allows full operation of the camera.
[2. Live only]:
Allows only to display the [Live] screen. No operation and setting of the camera is available.
f
Factory setting: [2. Live only]
[Host check]
Click of [Host check] to check the IP addresses of the registered hosts.
A host is indicated as “registered IP address and access level”. (Example: 192.168.0.21[1])
Clicking the [Delete] button on the right deletes the selected host (IP address).
[Network] screen
Configure the settings for network in the [Network] screen.
The following information is necessary to configure the network settings. Consult your network administrator or Internet service provider.
f
IP address
f
Subnet mask
f
Default gateway (when gateway server and router are to be used)
f
HTTP port
