18
Before using the camera
Before using the camera
r
LCD
f
The LCD monitor is manufactured with high-precision technology and has an effective pixel count of over 99.99%, but there are 0.01% of the pixels
either missing or constantly lit (red, blue, green). This is normal and not a cause for concern.
f
The LCD protective panel is specially treated. Wiping it or rubbing it vigorously with a hard cloth may scratch or mark its surface.
f
The response rate and brightness of the LCD depend on the ambient temperature.
r
Handling
f
Do not drop or apply excessive shock or vibration. Doing so may damage it.
r
Operating temperature range
f
The picture quality may degrade or there may be adverse effect to internal components when used in locations as follows. Avoid using in such
locations.
Cold location that is 0 °C (32 °F) or lower.
Hot location that is 45 °C (113 °F) or higher.
r
Maintenance
f
Clean the cabinet and LCD protection panel by gently wiping them with a soft cloth.
To remove stubborn soiling, use a cloth dampened in a weak neutral detergent solution and thoroughly wrung out. Then wipe with a dry cloth.
Any moisture entering the monitor could damage it.
f
Never use alcohol, thinner, or benzene to clean this unit.
Doing so may discolor the surface or cause the paint to peel.
f
Do not directly expose the monitor to spray detergent. Any moisture entering the monitor could damage it.
r
Connecting/disconnecting the connector
f
Be sure to power down the device before connecting or disconnecting the connector.
Features
This unit is an LCD viewfinder equipped with a 9.0-inch LCD panel.
This can be used as a viewfinder for the Studio Handy Camera (AK-UC3000G/AK-UC3000GS, AK-HC5000G/AK-HC5000GS, AK-HC3800G/
AK-HC3800GS, AK-HC3500AP/AK-HC3500AE/AK-HC3500AES).
Input of the external DC power supply is required when this unit is mounted to AK-HC3800G/AK-HC3800GS or AK-HC3500AP/AK-HC3500AE/
AK-HC3500AES.
The signal for video format is automatically distinguished and displays the video of the camera.
Setting for various markers, focus assist function, waveform display function, etc., can be set regardless of setting the viewfinder setting on this unit.
These functions can be assigned to the <F1>/<F2>/<F3>/<F4> buttons, and can be displayed directly by pressing the button.
Accessories
Hood
Camera number sheet (1 to 12)
12
8
4
11
7
3
10
6
2
9
5
1
@
@
NOTE
t
After unpacking the product, dispose of the packing material properly.
