Menu operations
33
Item
Setting content
[SHARPNESS MODE]
Selects the edge width of the contour correction (during peaking).
[HIGH]:
Narrow edge
[LOW]:
Wide edge
f
Factory setting: [HIGH]
[SHARPNESS H]
Sets the horizontal contour correction.
Adds to the operation of the <PEAKING> knob.
[0]…[30]
f
Factory setting: [0]
[SHARPNESS V]
Sets the vertical contour correction.
Adds to the operation of the <PEAKING> knob.
[0]…[30]
f
Factory setting: [0]
[MONO]
Switches between color and monochrome.
[OFF]:
Color.
[ON]:
Monochrome.
f
Factory setting: [OFF]
[SCAN]
Sets the underscan or normal display of the screen.
[NORMAL]:
Normal display.
[UNDER]:
Underscan.
f
Factory setting: [NORMAL]
[BACK LIGHT]
Adjusts the brightness of the LCD backlight.
[0]…[100]
f
Factory setting: [100]
[SYSTEM CONFIG]
Item
Setting content
[EXIT]
Returns to the upper level.
[WFM]
Sets if the waveform of the video signal input to viewfinder is displayed or not.
[FOCUS-IN-RED] is disabled when [WFM] is displayed while [FOCUS-IN-RED] is enabled.
[OFF]:
Not displayed.
[WFM]:
Displays the waveform of the brightness signal.
f
Factory setting: [OFF]
[WFM POSITION]
Selects the position of the waveform display when [WFM] is [ON].
[LB]:
Bottom left of the screen.
[RB]:
Bottom right of the screen.
[RT]:
Top right of the screen.
[LT]:
Top left of the screen.
f
Factory setting: [RB]
[TALLY ASSIGN]
Sets the illumination condition of the assignable tally lamp.
[OFF]:
Turns off.
[INPUT SDI]:
Turns on when the <INPUT> switch is set to <SDI>.
[INPUT CAM]:
Turns on when the <INPUT> switch is set to <CAM>.
[CAM MENU]:
Turns on when the menu operation function of the camera is enabled. Only when the
camera (AK-UC3000G/AK-UC3000GS, AK-HC5000G/AK-HC5000GS) is connected.
f
Factory setting: [OFF]
[MENU RESUME]
Sets the enable/disable of the menu resume function.
[OFF], [ON]
f
Factory setting: [OFF]
[POWER LED]
Sets the illumination condition of the <POWER> lamp.
[ON]:
Turns on continuously.
[OFF1]:
Turns off (setting will return to [ON] when the power is turned off/on).
[OFF2]:
Turns off continuously.
f
Factory setting: [ON]
[STATUS DISPLAY]
Sets the display condition of the status display.
[CONTINUE]:
Displays continuously.
[3SEC OFF]:
Displays for three seconds after changing the condition of the status display, and then
disappears.
[OFF]:
Not displayed.
f
Factory setting: [3SEC OFF]
[HOUR METER]
Item
Setting content
[EXIT]
Returns to the upper level.
[OPERATION]
Displays the total number of hours the power was turned on.
Hours up to 262800 hours [262800H] (approximately 30 years) is displayed. Hours exceeding 262800
hours is displayed as [OVER].
[LCD]
Displays the number of hours the backlight has been on.
Hours up to 262800 hours [262800H] (approximately 30 years) is displayed. Hours exceeding 262800
hours is displayed as [OVER].
