ANUP5204 Aicure
Irradiation
28
Setting Procedure for Pattern No. 0 to No. 8
Switch to Pattern Mode
1
On the operation panel, press the "PATTERN" button
until you hear a beep (at least 3 seconds). The system
enters pattern mode. The LED above the "PATTERN"
button lights, and the pattern number appears in the
display.
Select a Pattern Number
2
Press the "SET" button until you hear a beep (at least 1 second).
The LED above the "PATTERN" button begins to flash.
3
Press the up and down arrow buttons to change the
pattern number (0 to 8).
Press the up arrow button to increment the value.
Press the down arrow button to decrement the value.
Pattern number 9 is available via external signals.
Do not select this pattern, as it cannot be used in
ordinary pattern irradiation.
4
Press the "SET" button until you hear a beep (at least 1
second). Subsequent settings are performed on the
selected pattern number.
Set Each Step
5
On the operation panel, press the "SET" and down arrow
buttons simultaneously until you hear a beep (at least 1
second). The "TIME" LED under the display begins to flash,
and the step number and timer value appear in the display.
6
Press the up and down arrow buttons to change the value
(seconds). Press the up arrow button to increment the
value. Press the down arrow button to decrement the
value. Press and hold one of the buttons to speed the rate
of increase/decrease.
The value can be set from 1.0 to 99.9 seconds in
increments of 0.1 seconds, and from 100 to 999
seconds and beyond in increments of 1 second.
7
Press the "SET" button until you hear a beep (at least 1
second). If this is the value you wish to set, press the
"SET" button to register it. The "TIME" LED goes out, and
the "UV POWER" LED begins to flash. The step number
Warning
Warning
