– 125 –
Chapter 5 Shooting — Image quality adjustment
[KNEE MODE] (setting for knee operation mode)
1
Select the [SCENE FILE SETTINGS] menu
→
[KNEE]
→
[KNEE SW]
→
[ON].
2
Select the [SCENE FILE SETTINGS] menu
→
[KNEE]
→
[KNEE MODE]
→
[D RANGE]/[PRESS].
[D RANGE]:
Determines the dynamic range that can be represented by the [KNEE SLOPE] value. The value of dynamic range that can be
represented does not change even when the value of [KNEE POINT] changes.
[PRESS]:
Determines the signal compression rate by the [KNEE SLOPE] value. The value of the dynamic range that can be represented changes
when the [KNEE POINT] value changes.
r
[KNEE POINT] (knee point position setting)
1
Select the [SCENE FILE SETTINGS] menu
→
[KNEE]
→
[KNEE POINT].
2
Sets the position of the knee point.
r
[KNEE SLOPE] (setting for knee inclination)
1
Select the [SCENE FILE SETTINGS] menu
→
[KNEE]
→
[KNEE SLOPE].
2
Sets the knee inclination.
[HLG KNEE]
Sets to compress the video signal to prevent the halation in the image during HLG.
[KNEE MODE] (setting for knee operation mode)
1
Select the [SCENE FILE SETTINGS] menu
→
[HLG KNEE]
→
[KNEE SW]
→
[ON].
r
[KNEE POINT] (knee point position setting)
1
Select the [SCENE FILE SETTINGS] menu
→
[HLG KNEE]
→
[KNEE POINT].
2
Sets the position of the knee point.
r
[KNEE SLOPE] (setting for knee inclination)
1
Select the [SCENE FILE SETTINGS] menu
→
[HLG KNEE]
→
[KNEE SLOPE].
2
Sets the knee inclination.
[WHITE CLIP]
Sets so the brightest part of the video signal does not get higher than a specific level.
0
Input
Output
White clip level
1
Select the [SCENE FILE SETTINGS] menu
→
[WHITE CLIP]
→
[SW]
→
[ON].
2
From the [SCENE FILE SETTINGS] menu
→
[WHITE CLIP]
→
[LEVEL], set the level.
[DETAIL]
Sets the intensity of the outline to represent the image.
It can have soft representation or sharp representation, but then again, it can also have an effect to roughen the entire video by enhancing the noise or
edge.
To prevent the whole image to become rough, adjust so that the detail effect will remain in the area to enhance the detail, but to hold back the detail
effect in the area that does not require enhancement.
1
Select the [SCENE FILE SETTINGS] menu
→
[DETAIL]
→
[SW]
→
[ON].
2
Set the [SCENE FILE SETTINGS] menu
→
[DETAIL]
→
[CORING]/[MASTER LEVEL]/[FREQUENCY].
[CORING]:
Sets the level of signal (including noise) not to activate the detail effect.
[MASTER LEVEL]:
Sets the level of the detail effect of the whole part.
[FREQUENCY]:
Sets the thickness of the detail as a whole.
