– 141 –
Chapter 8 System Menu — System settings
System settings
Setting the video format function
One system format (input/output signal) can be selected.
@
@
NOTE
t
Do not change the format during any of the following operations:
- When loading from a memory card or saving to a memory card
- When loading from the Storage Module AV-HS60D1 or saving to the Storage Module AV-HS60D1
- When recording videos or still images
1
Select the <SYS> button
→
[SYSTEM]
→
[Video] tab.
2
Select an item in [Video Format] in the [Video Format] column.
f
Select a system format. Selectable items are as follows:
- Standard mode:
[1080/59.94i], [1080/50i], [1080/24PsF], [1080/23.98PsF], [720/59.94p], [720/50p], [480/59.94i], [576/50i], [1080/29.97PsF], [1080/25PsF]
- 3G mode
[1080/59.94p], [1080/50p]
- 4K mode
[2160/59.94p], [2160/50p]
3
Select an item in [16:9 Squeeze] in the [Video Format] column.
f
This setting is enabled when SD is selected as the system format.
f
When [16:9 Squeeze] is set to [On], a border width (wipe or PinP), which considers cases where SD format videos are converted to the 16:9
aspect ratio before use, is established.
[Off]
Squeeze mode is not supported.
[On]
Squeeze mode is supported.
r
Border width (graphical representation) when squeeze mode is supported
Squeeze (4:3)
16:9
Setting the output phase
The phase of the output video signals can be adjusted.
1
Select the <SYS> button
→
[SYSTEM]
→
[Video] tab.
2
Select an item in [System] in the [Output Phase] column.
[1H]
Outputs video signal with 1H delay against the system sync signal. When the frame synchronizer function is on, the
video signal is output with delay of 1 frame
+
1H.
[0H]
Output video signals are output in phase for the system sync signal. The frame synchronizer function is ON for all input
signals.
3
Select an item in [H‑Phase[H]] in the [Output Phase] column.
f
Adjust the H phase. It can be adjusted to a value from [
−
0.50H] to [0.49H].
4
Select an item in [V‑Phase [Line]] in the [Output Phase] column.
f
Adjust the V phase. It can be adjusted to a value from [
−
100H] to [100H].
r
Phase adjustment setup
f
The line synchronizer range is the draw-in range in which automatic phase adjustment is possible. The following illustration shows that the signal is
1080/59.94i.
Summary of Contents for AV-HS60C1E
