108
Input/output signal settings
8
Use [F4] to select the scaling method using the Scale
item.
Fit-V
The aspect ratio of the output images is
maintained, and the size of the images is
increased or reduced in accordance with the
vertical resolution.
(Black bands are inserted into the areas
where there are no images. The protruding
parts of the images are cropped.)
Fit-H
The aspect ratio of the output images is
maintained, and the size of the images is
increased or reduced in accordance with the
horizontal resolution.
(Black bands are inserted into the areas
where there are no images. The protruding
parts of the images are cropped.)
Full
The size of the output images is increased
or reduced in accordance with the system
resolution.
Fullx80%
The size of the output image is increased or
reduced in accordance with the 80% size of
the system resolution.
Fullx90%
The size of the output image is increased or
reduced in accordance with the 90% size of
the system resolution.
p
The aspect ratio is not maintained at the Full,
Fullx80% or Fullx90% setting.
The rate at which the image size is increased or
reduced in the vertical direction and in the horizontal
direction differs.
9
Use [F5] to set the image movement detection
sensitivity using the Move Detect item.
1
Toward still images
3
Standard
5
Toward moving images
Setting the down-converter (optional)
Select the settings for the down-converter that is built into the
SDI output unit (AV-UHS5M2).
1
On the Output sub menu, use [F2] to select the output
to be set using the Select item.
Refer to “Output signal settings”.
2
Use [F1] to display the Down Converter sub menu.
3
Use [F2] to set the delay time of the output using the
Delay item.
Minimum
Output is with the minimum delay of the
system. Refer to "Adjusting the output signal
phase" for the size of phase delays.
1F Fix
The image is output in-phase with a delay of
1 frame from the system image (HD).
4
Use [F3] to set the extent of the edge sharpness for the
images using the Sharp item.
1
Standard
5
Very sharp edges