99
Input/output signal settings
Setting the material names
Material names can be given to the input signals.
These names can be selected from the default settings or
user settings.
1
On the Input sub menu, use [F2] to select the input to
be set using the Select item.
Refer to “Input signal settings”.
2
Use [F1] to display the Name sub menu.
3
Use [F2] to select the type of material names using the
Type item.
Default
(default
settings)
Select the material names from the following:
IN1, IN2, 12G SDI IN3 to 8, IN-A1 to 4,
IN-B1 to 4
User
(user
settings)
The material names are set using up to 32
characters.
Setting the up-converter
Select the settings for SDI IN5 to SDI IN8, as well as for the
up-converter that is built into the optional unit listed below:
p
AV-UHS5M1 (SDI Input Unit)
1
On the Input sub menu, use [F2] to select the input to
be set using the Select item.
Refer to “Input signal settings”.
2
Use [F1] to display the Up/Down Converter sub menu.
3
Use [F2] to set the image movement detection
sensitivity using the Move Detect item.
1
Toward still images
3
Standard
5
Toward moving images
4
Use [F3] to set the extent of the edge sharpness for the
images using the Sharp item.
1
Not sharp edges
3
Standard
5
Very sharp edges
