32
SIMUL REC
When memory cards are inserted in both of the two slots, activating this function enables recording the
same video to both the memory cards. Set the [SIMUL REC] item on the setup menu [RECORDING
SETUP] screen to [ON] to enter the SIMUL REC mode.
In the media capacity display on the screen, the available recording time possible for SIMUL REC (the
available recording time of the memory card with lower memory capacity) is displayed, and the icon
[
] is displayed.
Slot 1
Slot 2
Clip A
Clip A
Clip B
Clip B
To resume the SIMUL REC, replace the memory card in Slot 1
to a new memory card and press the <START/STOP> button.
If you press the <START/STOP> button without replacing the
memory card, video will be recorded normally on the memory
card in Slot 2 (with remaining memory).
When the memory card with
lower remaining memory
becomes full, SIMUL REC will
stop. (This figure shows the
case that the memory card in
Slot 1 becomes full.)
Start
recording
End recording
Start recording
Clip C
Stop recording (memory full)
Memory card recording time
Standby
Standby
• SIMUL REC cannot be used at the same time as relay recording, VFR recording, or INTERVAL REC.
• During SIMUL REC, if recording has stopped because a recording error has occurred in one of the
memory cards, the other memory card will continue to record.
• After SIMUL REC ends, when there is capacity remaining on one of the memory cards, that memory
card will automatically be selected as the memory card for recording. Press the <START/STOP>
button again for normal recording.
• While in SIMUL REC mode, if only one memory card is inserted, normal recording takes place.
• After SIMUL REC, the REC CHECK function does not operate.
• After SIMUL REC, the [LAST CLIP] function does not operate.
• When switching to <PB> mode after SIMUL REC, the thumbnails of the memory card in slot 1 will be
displayed.
Summary of Contents for AVCCAM AG-AC160EJ
Page 110: ...2011 ...
