73
5
6
7
8
9
10
11
12
13
14
15
16
11. Service Switch
Default
: a full reset
The unit is in its default mode.
Initialization 1:
Reset the user authentication settings for
network connection. (This will delete all the
registered user information (IDs/passwords).
After configuring the SERVICE switch in the
manner of the following illustration, power on
the unit.
[Note]:
1. Once Initialization
1 is configured
properly, the unit’s status indicator LED
blinks green.
2. Restore the SERVICE switch to its
previous setting. (Both SW1 and SW2
are set to OFF.)
3. Restart the unit to fully accomplish the
setting of Initialization
1.
Initialization 2
Initialization 2 restores the unit to its factory
default, including the setting of the menu, and
the Network Configuration.
After configuring the SERVICE switch in the
manner of the following illustration, power on
the unit.
[Note]:
1. Once Initialization 2 is configured
properly, the unit’s status indicator LED in
front of the unit blinks green.
2. Restore the SERVICE switch to its
previous setting. (Both SW1 and SW2
are set to OFF.)
3. Restart the unit to fully accomplish the
setting of Initialization 2.
