- 8 -
Mounting
1
Unplug the camera’s power connector from the camera.
2
Loosen the 4 screws (8 mm) on the rear of the camera
and remove the rear panel.
3
Loosen the 2 screws (6 mm) for the option card slot cover
and remove the option card slot cover.
4
Insert the SDI card along the guide rail at the bottom of
the camera and the tab above. Insert it securely all the
way.
5
Tighten the 2 screws (6 mm) for the option card slot cover
securely.
6
Fasten the rear panel with the 4 screws (8 mm).
7
Plug the cables back as necessary, connect the power
connector, then switch power on.
NOTE
Be sure to ask your store, where you purchased the
product, for mounting.
Disconnect the camera power connector before mounting.
Before handling the SDI card, touch a metal part of the
camera to discharge the static from the human body.
An anti-static wrist strap is recommended for added safety.
If you touch the SDI card while you are still charged
with static, it may cause trouble.
Keep the metal parts of the SDI card free of contact
with other metal parts.
If you have lost the screws, use the screws supplied as
accessories.
Rear panel
SDI card
2 screws (6 mm)
4 screws (8 mm)
Optional card slot cover
AW-PB504N(VQT0H53-2)英.indd 8
2008/09/03 16:34:27