- 17 -
Installation
(The installation work must be performed by your dealer without fail.)
O
Mounting a camera
When mounting a camera to the pan/tilt
head, take appropriate measures to
prevent the camera from falling or being
stolen.
1. Place the camera on the camera
mounting base and insert the guide pin
into the guide hole on the camera.
2. Tighten the 2 camera mounting screws
to fix the camera firmly in place.
3. After mounting the camera, check that it
is firmly attached and that there is no
play.
<Notes>
O
Be sure to tighten all screws firmly with a
screwdriver or similar tool.
O
When there is only 1 hole on the
camera, remove the 2 camera mounting
screws from the camera mounting base,
then insert 1 camera mounting screw
into the center hole on the camera
mounting plate and tighten it to fix the
camera in place.
O
Adjusting slack in the chain
The chain length allows for some degree
of slack.
Remove any slack after attaching the
camera to the pan/tilt head by twisting
the chain around as shown in the figure
at right, then firmly tighten the screw to
fix it in place.
Camera mounting Screw
Camera guide pin
Camera mounting Screw
With the AW-E655/AW-E750/AW-E860
With the AW-E350/AW-E650
