1. Remove the belt by rotating pulley B.
2. Remove the lock nut and then pulley B and the lock washer.
3. Remove the U-cripe and pull out the connector lower unit.
1. Remove the four screws that secure the heater case base
and remove it.
2. Remove the heater case.
Caution:
Attach the heater case base to the alignment mark of
the heater case.
Fig.22
No.
Parts Name
1
Belt
2
Lock nut
3
Lock washer
4
Pulley B
5
U-cripe
6
Motor washer A
7
Connector lower Unit
8
Heater case base Unit
9
Angle
Caution:
Attach the shaft, pulley B and the lock washer by aligning
the "D" cut of each part.
Fig.23
No.
Parts Name
1
Heater case
2
Set Mark
3
Set Mark
4
Heater case base Unit
5
Screw
3.15. Belt, Pulley B, and Connector lower unit
3.16. Heater case base and Heater case
19
SD-253
Summary of Contents for Bread Bakery SD-253
