Panasonic CF-19FDGAXCM, Operating Instructions Manual

13

Getting Started

3 

Turn on the computer.

A

 Pull up the part (A) and release the latch.

B

 Lift open the display.

C

 Slide and hold the power switch (B) for approximately one second until the 

power indicator   lights.

 CAUTION 

  Do not slide the power switch repeatedly.

  The computer will forcibly be turned off if you slide and hold the power switch for 

four seconds or longer.

  Once you turn off the computer, wait for ten seconds or more before you turn on 

the computer again.

  Do not perform the following operation until the hard disk drive indicator   turns off.

  Connecting or disconnecting the AC adaptor

  Sliding the power switch

  Touching the keyboard, touch pad, tablet buttons, touchscreen (only for model 

with touchscreen), digitizer (only for model with digitizer) or external mouse

  Closing the display

  When the CPU temperature is high, the computer may not start up to prevent 

overheating of the CPU. Wait until the computer cools down, and then turn the 

power on again. If the computer does not power on even after cooling down, 

contact Panasonic Technical Support.

4 Setup 

Windows.

A

 Follow the on-screen instructions.

 CAUTION 

  When you set date/time/time zone and click [Next], the screen may not go to the 

next step for a few minutes. Do not touch the keyboard or touch pad, and wait 

until the screen changes.

  If “An unexpected error has occurred…” (or a similar message) is displayed, 

click [OK]. This is not a malfunction.

  Wait until the hard disk drive indicator   has turned off.

  This computer periodically records the management information including the 

hard disk information such as number of hours powered-on, number of times 

powered-on, internal temperature, replacement sector. The maximum data vol-

ume for each record is 750 byte. These information are only used for estimating 

the cause when the hard disk goes down by any possibility. They are never sent 

to outside via network nor used for any other purpose except for the purpose 

described the above. 

To disable the function, add the check mark for [Disable the automatic save 

function for management information history] in [Hard Disk Status] of PC Infor-

mation Viewer, and click [OK].

<For MUI OS model>

  The keyboard will operate as the US keyboard until the keyboard setting is 

changed. Because of this, some alphabets shown on display may differ from 

inputted ones.

To avoid the accidental selections, during setting up Windows,

  Use the touch pad to make some selections.
  Press the NumLock key and input in the Ten-key mode to input numbers.

  To match the languages, change the language settings after setting up Win-

dows (  page 14). Do not change the settings in [To change system or these 

settings, click Customize] of [Regional and Language Options] during setting up 

Windows.