Panasonic CF-19FDGAXCM, Operating Instructions Manual

4

Getting Started

Read Me First

FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY

This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 3 amp fuse is 

fi

 tted 

in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 3 amps and that it is ap-
proved by ASTA or BSI to BS 1362.

Check for the ASTA mark 

A S A

 or the BSI mark 

 on the body of the fuse.

If the plug contains a removable fuse cover you must ensure that it is re

fi

 tted when the fuse is replaced.

If you lose the fuse cover the plug must not be used until a replacement cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic Dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE 
SHOULD BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP 
SOCKET.
If a new plug is to be 

fi

 tted please observe the wiring code as shown below.

If in any doubt please consult a quali

fi

 ed electrician.

Warning: THIS APPLIANCE MUST BE EARTHED.
Important

The wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow: Earth
Blue: Neutral
Brown: Live

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identi-
fying the terminals in your plug, proceed as follows: The wire which is coloured GREEN-and-YELLOW must be con-
nected to the terminal in the plug which is marked by the letter E or by the safety earth symbol 

 coloured GREEN or 

GREEN-and-YELLOW.

The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured 
BLACK.
The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured 
RED.
The mains plug on this equipment must be used to disconnect the mains power.
Please ensure that a socket outlet is available near the equipment and shall be easily accessible.

  How to replace the fuse

Open the fuse compartment with a screwdriver and replace the fuse.

Warnings

  This equipment is not designed for connection to an IT power system.

(An IT system is a system having no direct connections between live parts and Earth; the exposed-conducive-parts 
of the electrical installation are earthed.

An IT system is not permitted where the computer is directly connected to public supply systems in the U.K.)

  Disconnect the mains plug from the supply socket when the computer is not in use.

This equipment is produced to BS800/1983.

8-E-1

<Only for model with Bluetooth>

Communication using Bluetooth outdoor is against the law.
Do not use Bluetooth outdoors.

37-M,E-1