18
Operation
3
Select your operating system
Select Windows NT Workstation Version 4.00 and press
Enter
.
4
Logon
Press
Ctrl
+
Alt
+
Del
.
5
Input your password
Wait for 10 seconds after confirming that the HDD access has been completed, and input
the user name and password, then press [OK]. Until the correct user name and password
are entered, the computer will not operate.
Windows NT
If [Cancel] is clicked, the computer will return to the initial [Begin Logon] display.
Starting Up/Shutting Down
Windows NT
If the right screen is displayed:
When the AC adaptor is connected, press [Yes],
and then restart the computer.
When the AC adaptor is not connected, press
[No].
Windows NT
Windows NT
NOTE
Windows 2000
6
Select your application
You are able to start working on your computer.
The power saving function is factory set, so if there is no input from a key, the touch pad
or an external mouse (when one is connected) for a certain interval of time, the power to
the LCD and hard disk may be turned off. The LCD will resume operation when the
touch pad or an external mouse (when one is connected) is used or a key is pressed.
The power to the LCD may be turned off while Windows is setting up or even when an
application software is being installed. In this case, because it is conceivable that a
selection dialog box will be shown, do not press
Space
or
Enter
to attempt to
resume from this condition as doing so may trigger a selection, but instead, press a key
unrelated to the direct triggering of a selection, like
Ctrl
.
Windows 98
Windows 2000
In addition, when the computer is left alone, it automatically enters the standby*
1
mode
(
Standby/Hibernation Functions). The computer will resume by sliding
the power switch.
Windows 98
Windows 2000
[System devices] in [Start] - [Settings] - [Control Panel] - [System]*
2
-[Device Man-
ager] may contain a device or devices bearing an exclamation mark or question mark.
This does not indicate a malfunction. Such a mark (exclamation mark or question mark)
will not be displayed if the operating environment of the device showing the mark is
corrected, by for instance installing the driver of the device.
*
1
Windows 2000: standby or hibernation
*
2
Windows 2000: [System] - [Hardware]
NOTE
Windows NT
