15
G
e
tti
ng S
ta
rt
ed
The battery charging starts automatically.
CAUTION
z
Do not disconnect the AC adaptor and do not switch the wireless switch to on
until the first-time operation procedure is completed.
z
When using the computer for the first time, do not connect any peripheral
device (including wired LAN cable) except the battery pack and AC adaptor.
z
Handling the AC adaptor
Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible power
source (UPS) is highly recommended unless running from the battery pack alone.
Open the display, and slide and hold the power switch
(
Î
page 12) until the
power status indicator (
Î
page 12) lights.
NOTE
z
If the remaining charge of the built-in battery is less than 50%, performance of
the computer is degraded. We recommend you to charge the built-in battery for
20 minutes or more before starting setup of Windows.
CAUTION
z
Carefully choose your language because you cannot change it later. If you set a
wrong language, you need to reinstall Windows.
A
Select language on “Your display language” and click [Next].
Follow the on-screen instructions.
A
Select language and OS (32bit or 64bit) on “Select OS” screen and click [OK].
The language setting will start by clicking [OK] on the confirmation screen.
You can return to the “Select OS” screen by clicking [Cancel].
The language and OS setting will be completed in about 15 minutes.
B
When termination screen is displayed, click [OK] to turn off the computer.
C
Turn on the computer.
Follow the on-screen instructions.
z
The computer restarts several times. Do not touch the keyboard or touch pad,
and wait until the drive indicator
has turned off.
z
After the computer is turned on, the screen remains black or unchanged for a
while, but this is not a malfunction. Wait for a moment until the Windows setup
screen appears.
z
During setup of Windows, use the touch pad and clicking to move the cursor
and to click an item.
z
Setup of Windows will take approximately
5 /
20 minutes.
Go to the next step, confirming each message on the display.
z
Follow the steps below.
A
When “Enable sensors” is displayed, click [Enable this sensor].
B
When the [User Account Control] screen is displayed, click [Yes].
3
Connect your computer to a power outlet.
DC IN 16 V
3
4
Turn on the computer.
5
<For MUI OS model>
Select language.
Select language and OS (32-bit or 64-bit).
6
Setup Windows.
CF-AX2mk1(CPE02709YA)_OI_M.book Page 15 Wednesday, May 22, 2013 11:06 AM
