10
When connecting the serial device
Touchscreen
1
Turn the computer off and remove the serial device connected to the serial port of the
port replicator.
2
Turn the computer on.
3
Logon the computer.
4
Select
from the task bar or select [Settings] from [Start] - [Programs] - [Updd].
The following is displayed.
5
Select [device2] in [Devices] - [The following devices are installed] and select [Re-
move].
At the confirmation message, select [OK].
6
Turn the computer off and connect the serial device to the serial port.
The touchscreen is set so that Device 1 (touchscreen of the computer) and Device 2
(CF-VDL01 (optional) connected to the serial port of the port replicator) both operate.
When connecting the serial device to the serial por t of the port replicator, if Windows
does not start or the serial device does not work properly, change the settings of the
touchscreen driver with the following procedure.
1
Select
from the task bar or select [Settings] from [Start] - [Programs] - [Updd].
2
Select [device2] in [Devices] - [The following devices are installed] and select
[Calibrate].
When the touchscreen driver is reinstalled, the calibration of Device 1 and the cali-
bration of Device 2 may be requested. In such case, if the LCD monitor (CF-VDL01
(optional)) is not connected to the serial port of the port replicator, the calibration of
Device 2 times out. In this case, carry out the calibration of Device 2 again with the
following procedure.
NOTE
