16
Standby/Hibernation Functions
Standby Mode
or
Hibernation Mode
The computer should be set for standby or hibernation (
page 15
).
Slide the power switch; at
the “beep*
1
” sound, re-
lease your finger.
(After releasing your finger from the
power switch, do not touch the power
switch until the power indicator goes
off or blinks.)
At the “beep” sound, release your finger from the power switch. If you continue to
press down on the switch and hold it for more than four seconds, the unit will emit
a second “beep” then power off. Data not previously saved will be lost.
Windows 98
Windows 2000
Even when [When I press the power button on my computer] is set to [Shut-
down]*
2
with [Control Panel] - [Power Management]*
3
, if the power switch is
pressed, a beep will sound and the power will go off if the switch is pressed for
more than four seconds, although the computer will not completely shut down.
With the method below, you can shut down the computer by using the standby
function.
• Fn + F7 (
page 2
)
Windows 98
Windows 2000
• In [Start] - [Shut Down], select [Stand by].
Windows 2000
With the method below, you can shut down the computer by using the hiberna-
tion function.
In [Start] - [Shut Down], select [Hibernate].
Shutting Down Using the Standby or Hibernation Function
CAUTION
NOTE
*
1
When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the Setup
Utility (
page 52
) or by the key combination Fn + F4 , there will be no beep sound.
*
2
Windows 2000
: [Power Off]
*
3
Windows 2000
: [Power Options]
