9
Using the Touch Pad
Using the Virtual Scrolling Function
Set the Virtual Scrolling function using the following procedure. The Touch Pad utility will be disabled.
1
Click
on the notification area, and click [Settings].
When
is not displayed:
, step
1
-
A
2
Remove a check mark from [Use Touch Pad function] in [General settings], and then click
[OK].
3
Click [start] - [Control Panel] - [Printers and Other Hardware] - [Mouse] - [Device Set-
tings].
4
Click the device name (e.g., Synaptics TouchPad) in [Devices] , then click [Settings].
5
Click [Virtual Scrolling], add a check mark for the scroll functions you want to use, then
click [OK].
6
Click [OK] at [Mouse Properties].
NOTE
Because the Touch Pad utility and the Virtual Scrolling function both offer scrolling
functions that use the Touch Pad, these two features cannot be used simultaneously.
If you try to use them at the same time, a message may be displayed asking you if
you want to enable the Touch Pad utility.
• To use the Touch Pad utility: Click [Yes]. The Virtual Scrolling function will be
disabled.
• To use the Virtual Scrolling function: Click [No].
You can uninstall the Touch Pad utility using the following procedure.
A
Click
or
on the notification area, and then click [Exit].
B
Click [start] - [Control Panel] - [Add or Remove Programs] - [Touch Pad Utility], and then click [Change/Remove] to
remove the program.
To begin using the Touch Pad utility again:
A
Click [start] - [Control Panel] - [Add or Remove Programs].
When [Touch Pad Utility] is not displayed, perform the following procedures from step
B
.
When [Touch Pad Utility] is displayed, perform the following procedures from step
C
.
B
Input [c:\util\touchpad\setup.exe] in [start]-[Run] and then click [OK].
Follow the on-screen instructions.