Panasonic CF-W7 Series, Operating Instructions Manual

3

Get

ting St

arted

U

seful In

formati

on

Troubleshooting

Appendix

Read Me First

<Only for model with a “

” mark on the bottom of the computer>

Federal Communications Commission Radio Fre-

quency Interference Statement

Note: This equipment has been tested and found to com-

ply with the limits for a Class B digital device, pursuant to 

Part 15 of the FCC Rules. These limits are designed to 

provide reasonable protection against harmful interfer-

ence in a residential installation. This equipment gener-

ates, uses and can radiate radio frequency energy and, if 

not installed and used in accordance with the instructions, 

may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not 

occur in a particular installation. If this equipment does 

cause harmful interference to radio or television recep-

tion, which can be determined by turning the equipment 

off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and 

receiver.

Connect the equipment into an outlet on a circuit differ-

ent from that to which the receiver is connected.

Consult the Panasonic Service Center or an experi-

enced radio/TV technician for help.

Warning

To assure continued compliance, use only shielded inter-
face cables when connecting to a computer or peripheral.  
Also, any changes or modifications not expressly 
approved by the party responsible for compliance could 
void the user’s authority to operate this equipment.

6-M-1

FCC RF Exposure Warning:

This computer is provided with a PC Card slot that could 
be used with wireless transmitter(s), which will be spe-
cifically recommended, when they become available.
Other third-party wireless transmitter(s) have not been 
RF exposure evaluated for use with this computer and 
may not comply with FCC RF exposure requirements.

<Only for model with wireless LAN/wireless WAN/Bluetooth>

This equipment complies with FCC radiation exposure 
limits set forth for an uncontrolled environment.
This equipment must be installed and operated in 
accordance with provided instructions and minimum 
1.5 cm spacing must be provided between antenna 
and all person’s body (excluding extremities of hands, 
wrist and feet) during wireless modes of operation.
This transmitter must not be co-located or operated in 
conjunction with any other antenna or transmitter.

25-M-2-3

<Only for model with wireless LAN>
This product is restricted to indoor use due to its operation 
in the 5.15 to 5.25 GHz frequency range.
FCC requires this product to be used indoors for the fre-
quency range 5.15 to 5.25 GHz to reduce the potential for 
harmful interference to co-channel Mobile Satellite sys-
tems. High power radars are allocated as primary users of 
the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These 
radar stations can cause interference with and/or damage 
this product.

25-M-W-1

This device complies with Part 15 of the FCC Rules.  
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, includ-

ing interference that may cause undesired operation.

Responsible Party: Panasonic Corporation of North America

One Panasonic Way
Secaucus, NJ 07094
Tel No:1-800-LAPTOP5 (1-800-527-8675)

6-M-1

FCC Regulation Notice for modem

This equipment contains a FCC approved modem.

1. This equipment complies with CFR47 Part 68 rules. 

On the computer is a label that contains, among other 

information, the FCC registration number and ringer 

equivalence number (REN) for this equipment. If 

required, this information must be provided to the tele-

phone company.

2. An FCC compliant telephone cord and modular plug is 

provided with this equipment. This equipment is 

designed to be connected to the telephone network or 

premises wiring using a compatible modular jack 

which is Part 68 compliant. See Installation Instruc-

tions for details.

3. The REN is used to determine the quantity of devices 

which may be connected to the telephone line. Exces-

sive RENs on the telephone line may result in the 

devices not ringing in response to an incoming call. In 

most, but not all area, the sum of RENs should not 

exceed five (5.0). To be certain of the number of 

devices that may be connected to a line, as deter-

mined by the total RENs, contact the local telephone 

company.

4. If your telephone equipment cause harm to the tele-

phone network, the telephone company will notify you 

in advice that temporary discontinuance of service 

may be required. But if advice notice isn’t practical, the 

telephone company will notify the customer as soon as 

possible. Also, you will be advised of your right to file a 

complaint with the FCC if you believe it is necessary.

5. The telephone company may take changes in its facili-

ties, equipment, operations or procedures that could 

affect the operation of the equipment. If this happens 

the telephone company will provide advance notice in 

order for you to make necessary modifications to 

maintain uninterrupted service.

6. If trouble is experienced with this equipment, for repair 

or warranty information, please contact Panasonic 

Corporation of North America at DIAL TOLL FREE 1-

800-LAPTOP5 (1-800-527-8675). If the equipment is 

causing harm to the telephone network, the telephone 

company may request that you disconnect the equip-

ment until the problem is resolved.

7. There are no user serviceable parts contained in this 

equipment.

Models for U.S.A.