Page 1-44
Check Every 140 Hours (Once a Week)
1-4-5
Checking and Lubricating the Board Conveyor
NOTICE
This maintenance is current-carrying operation. When you open the safety cover,
the power of XY motor is cut. So be sure to open the safety cover to operate.
Ensure that no trouble on the board transfer belt and roller on the board conveyor.
∗
For DU/DHU specifications, it is necessary to remove the feeder base cover for the maintenance.
1-2-3 Setting and Removing the Feeder Base Cover (Only for DU/DHU Specifications)
1.
Checking for damage to the belt and the eccentricity of the roller
1.
Turn OFF the servo switch.
2.
Open the safety cover.
3.
Check the belt visually at the end of
each conveyor, by turning it by hand.
After the check, exchange is necessary ;
1-6-1 Exchanging the Board Transfer Belt
444C-E-MMA01-A06-05
Tools
Push-pull gauge and broom
Required time
10 minutes
OFF ( ) ON ( )
SERVO
444C-083P
For D/DU
For DH/DHU/DK/DS
4H4C-504P