Page 1-48
Check Every 140 Hours (Once a Week)
15.
Close the safety cover.
16.
Turn ON the servo switch.
17.
Press Width adjust .
18.
Press
UNLOCK
+ continuous moving .
•
The movable side rail of the board conveyor
goes back and forth on the width adjustment
axis at full stroke, and spreads the grease over
whole area of the width adjustment ball screw
and width adjustment linear shaft.
19.
Press
UNLOCK
+ .
•
The board holder rises to the exchange
position.
20.
Turn OFF the servo switch.
21.
Open the safety cover.
22.
Insert the support pin into the support
pin receiver.
∗
When the support pin batch exchange table is
pulled out, return it back.
1-4-4 Cleaning the Support Pin Batch
444C-E-MMA01-A06-04
OFF ( ) ON ( )
SERVO
OFF ( ) ON ( )
SERVO
2
1
Pin change
Rise
Support pin
3
444C-417P