7
1
E
N
G
L
I
S
H
CQ-C5303N
6
Preparation
The demonstration message appears for initial
use.
q
Set your car’s ignition switch to the ACC or ON position.
w
Press
[SRC/PWR]
.
The demonstration screen appears.
e
Press and hold
[VOLUME] (PUSH SEL)
for more
than 2 seconds to open the menu.
r
Press
[VOLUME] (PUSH SEL)
to select the
Demonstration setting. (“DEMO” is displayed)
t
Turn
[VOLUME]
counterclockwise. (Press
[0] (
{
)
on
the remote control unit.)
a
Note:
¡
To return to the regular mode, press
[D] (DISP)
.
¡
Refer to section on “Function Settings” (
a
Page 30).
Main Unit
For an ACC-equipped car, select ON. (
a
Page 34) The
following functions are available. (Default: off)
¡
The power is turned on automatically when inserting a
disc.
¡
The clock can be displayed even if the power is off.
(
a
Page 11)
¡
After the security function (
a
Page 34) is set to ON, the
function works when turning the ignition switch to OFF.
:
ACC not equipped
(Default)
:
ACC equipped
Caution
¡
Be sure to select OFF when your car has no
ACC position in the ignition switch. Failure to
do this could cause the battery to go dead.
Cancellation of Demonstration
ACC Setting
Warning
¡
Keep a battery away from children to avoid the risk of
accidents. If an infant ingests a battery, please seek
immediate medical attention.
Caution
¡
Remove and dispose of an old battery immediately.
¡
Do not disassemble, heat or short a battery. Do not
throw a battery into a fire or water.
¡
Follow local regulations when disposing of a battery.
¡
Improper use of a battery may cause overheating, an
explosion or ignition, resulting in injury or a fire.
Note:
¡
Battery Information:
Battery Type: Panasonic lithium battery (CR2025)
(Included in the remote control)
Battery Life: Approximately 6 months under normal use
(at room temperature)
Remote Control Unit
Preparation Before Initial Use
Pull the insulation film out from the
backside of remote control gently.
Battery Replacement
q
w
q
Remove the battery holder with the
remote control unit placed on a flat
surface.
q
Stick your thumbnail into the
groove, and push the holder in the
direction of the arrow, and at the
same time.
w
Pull it out in the direction of the
arrow using a tough pointed object.
2
3
w
Put a battery in the case with (+) side
facing up.
e
Put the case back.
Tough pointed
object
Back side
[SRC/PWR]
(Power)
[D] (DISP)
[VOLUME] (PUSH SEL
: Select
)
