CQ-DX100W
2
Safety Information
Warning
❐
This installation information is designed for professional installers with knowledge of automobile electrical safety sys-
tems and is not intended for non-technical, do-it-yourself individuals. It does not contain instructions on the electrical
installation and avoidance of potential harm to air bag, anti-theft and ABS braking or other systems necessary to install
this product. Any attempt to install this product in a motor vehicle by anyone other than a professional installer could
cause damage to the electrical safety system and could result in serious personal injury or death.
❐
If your car is equipped with air bag and/or anti-theft systems, specific procedures may be required for connection and
disconnection of the battery to install this product. Before attempting installation of this electronic component against
the manufacturer’s recommendation, you must contact your car dealer or manufacturer to determine the required proce-
dure and strictly follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOYMENT OF AIR BAGS OR ACTIVA-
TION OF THE ANTI-THEFT SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND PERSONAL INJURY OR DEATH
.
53 mm
182 mm
4.5 mm – 6.0 mm
0 – 30
°
Consult a professional for installation.
Verify the radio using the antenna and speakers before installation.
Mounting Angle
Mounting Space
side to side : horizontal
front to rear : 0 – 30°
Supplied Hardware
1
1
1
1
2
1
Mounting Collar
Mounting Bolt (5 mmø)
Rubber Bushing
Trim Plate
Power Connector
Lock Cancel Plate
＊
＊
＊
＊
No.
Diagram
Q'ty
Item
No.
Diagram
Q'ty
Item
1
1
Conversion Cable
for AV1 IN
Clip Connector
*
w
,
e
,
y
and
i
consist of a set. (ZZBISDX200W)
(YFC054C095CA)
(
FX0214C384ZB
)
(YAJ024C126CA)
(YEAERA33000K)
182 mm
53 mm
4.5 mm – 6 mm
¡
Exclusively operated with 12 V battery with negative
(–) ground.
¡
Connect the power lead (red) very last.
¡
Connect the battery lead (yellow) to the positive (+)
terminal of the battery or fuse block terminal (BAT).
¡
Apply insulating tape to bare leads.
¡
Secure loosened leads.
Before Installation
Before Wiring
DX100W̲II̲01̲eng.qxd 07.11.22 6:36 PM ページ2
