5
TO SET THE TIMER
TO SET THE TIMER
•
,
,
and
can be activated
in all modes and can be cancelled by pressing the
respective button again.
•
and
or
and
can not
be activated at the same time.
•
and
can be activated even when the
unit is turned off. In this condition, once e-ion indicator
is ON, the unit will operate with AUTO fan speed and
air swing.
TO SELECT FAN SPEED
(5 OPTIONS)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
TO ADJUST VERTICAL AIRFLOW
DIRECTION (5 OPTIONS)
• Keeps the room ventilated.
• If AUTO is set, the louvers swing up/down
automatically.
• In heat mode, the air blows horizontally for a while,
then starts to blow downwards.
TO MONITOR AIR QUALITY
• Patrol sensor detects air quality.
• When air quality is unsatisfactory, e-ion operation will
start automatically.
TO ENJOY CLEAN AIR
• This operation produces negative ions to attract dust
which will then be captured at the positively charged
e-ion
fi
lters.
TO ENJOY QUIET ENVIRONMENT
• This operation reduces air
fl
ow noise.
TO ACHIEVE TEMPERATURE
QUICKLY
• This operation will stop automatically after 20
minutes.
• To turn ON or OFF the unit at a preset time.
Select ON or
OFF timer.
Set the time.
Con
fi
rm.
• To cancel ON or OFF timer, press
or
then
press
.
• When ON Timer is set, the unit may start earlier (up
to 30 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control Preparation at back
cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
.
OPTIONAL SETTINGS
OPTIONAL
SETTINGS
Patrol starts automatically with the unit
switched on with
.
Press and hold for 5 seconds, then release
to disable or restore this setting.
Press and hold for 5 seconds to dim or
restore the unit’s indicator brightness.
Press and hold for approximately 10
seconds to show temperature setting in
°C or °F.
Press and hold for approximately 5 seconds
to show 12-hour (am/pm) or 24-hour time
indication.
Press to restore the remote control’s default
setting.
,
Not used in normal operations.
Set the temperature 1°C higher in cool mode or 2°C
lower in heat mode than the desired temperature to
achieve a 10% power saving.
Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.
F565726.indd 5
F565726.indd 5
6/7/2007 12:26:14 PM
6/7/2007 12:26:14 PM
