Panasonic CS-E12QD3RW, Operating Instructions Manual

NON SERVICEABLE CRITERIAS

TURN OFF POWER SUPPLY then please consult 
authorised dealer under the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote 

control.

• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.

7

English

To set the timer

Daily timer setting

To turn ON or OFF the unit at a preset time.

TIMER/CLOCK

CANCEL

CLOCK

SELECT

MODE

OFF/ON

SET

UP

DOWN

3
4

1

2

1

Press TIMER 

MODE

 to enter timer mode

• Press once to change the display from 

clock to timer or vice-versa.

• Press for 4 seconds to change the display 

from daily timer to weekly timer or vice-
versa.

2

Select ON or OFF 
timer

Example: 
OFF at 22:00

OFF/ON

3

Set the time

UP

DOWN

4

Confi rm

SET

• To cancel, press 

CANCEL

.

• When ON timer is set, the unit may start early 

before the actual set time in order to achieve 
the desired temperature on time.

• Timer operation is based on the clock set in 

the remote control and repeats daily once set.

• The timer closest to the current time will be 

activated 

fi

 rst.

• If timer is cancelled manually or due to power 

failure, you can restore the previous setting 
by pressing 

SET

.

How to use / Information / 

To

 set the timer

To ensure optimal performance of the unit, 
cleaning has to be carried out at regular 
intervals. Please consult authorised dealer.

• Switch off the power supply before cleaning.
• Do not touch the aluminium 

fi

 n, sharp parts 

may cause injury.

• Do not use benzine, thinner or scouring 

powder.

• Use only soap (  pH 7) or neutral household 

detergent.

• Do not use water hotter than 40 °C.

For seasonal inspection after extended 
non-use

• No obstruction at air inlet and air outlet 

vents.

• These units are mounted inside the ceiling. 

It uses external air intake vent and air 
outlet vent to operate. Please consult your 
nearest dealer for seasonal inspection.

• After 15 minutes of operation, it is normal to 

have the following temperature difference 
between air inlet and air outlet vents: 

COOL: 

≥

8 °C

HEAT: 

≥

14 °C

For extended non-use

• Activate HEAT mode for 2~3 hours to 

remove moisture left in the internal parts 
thoroughly to prevent mould growth.

• Turn off the power supply.