10
REMOTE CONTROLLER (CONTINUED)
USING THE REMOTE CONTROLLER
Temperature Display Selector
button
This switches the temperature display between °C and °F.
Time Display Selector button
This switches the time display between 24-hour time and 12-hour time.
ACL button (ALL CLEAR)
Puts the remote controller into pre-operation status. Always press this button
after replacing the batteries.
ADDRESS switch
•
The address switch changes to prevent mixing of signals from remote
controller’s when two air conditioners are installed next to each other.
Normally, the address switch is set to A. For more information, please contact
the dealer where you made the purchase.
•
Normally, the tabs on the remote controller should not be bent.
The remote controller sends the temperature signal to the air conditioner regularly at five minute intervals.
If the signal from the remote controller stops for more than 15 minutes due to the loss of the remote
controller or other trouble, the air conditioner will switch to the temperature sensor which is built into the
indoor unit and control the room temperature. In these cases, the temperature around the remote
controller may differ from the temperature detected at the air conditioner’s position.
How to Install Batteries
•
The batteries last about six months, depending on how much you use the remote
controller. Replace the batteries when the remote controller’s display fails to light, or
when the remote controller cannot be used to change the air conditioner’s settings.
•
Use two fresh leak-proof type-AAA alkaline batteries.
•
In replacing batteries, follow the instructions as mentioned in the sub-section “How to
Install Batteries”.
•
If you do not use the remote controller more than 1 month, take out the batteries.
•
Dispose of the used batteries at the designated location in compliance with the
applicable local ordinances.
NOTE
1.
Slide the cover in the direction indicated by the
arrow and remove it.
2.
Install two AAA alkaline batteries. Make sure the
batteries point in the direction marked in the
battery compartment.
3.
Use a thin object such as the tip of a pen to press
the ACL button.
ACL button
CAUTION
Information for Users on Collection and Disposal of Old Equipment and used Batteries
[Information on Disposal in other Countries
outside the European Union]
These symbols are only valid in the European
Union. If you wish to discard these items,
please contact your local authorities or dealer
and ask for the correct method of disposal.
Note for the battery symbol (bottom two
symbol examples):
This symbol might be used in combination with
a chemical symbol. In this case it complies with
the requirement set by the Directive for the
chemical involved.
